Gutter Installation, Cleaning & Repair in Richmond, CA

If the rust is at one seam or one end cap, a repair can buy time. If you can see rust bloom along the bottom of the run or the water stains the fascia in several places, the steel is thinning from the inside and replacement with seamless aluminum is the honest answer. We will walk it with you and show you which it is.

Salt air off San Pablo Bay and months of fog. Galvanized steel gutter depends on its zinc coating, and once salt and standing moisture get through at a seam the steel underneath goes quickly. Aluminum does not rust, and copper only builds a patina, which is why we recommend both over steel anywhere close to the bay.

Yes, and it is common on 1920s to 1950s Richmond homes. Years of overflow soak the fascia board, and new gutter screwed into soft wood will pull loose within a season. We replace the damaged fascia, prime it, and then hang the new seamless run into solid wood so the system lasts.

The gutter itself is the same. The difference is where the water goes. On a hillside lot a downspout that dumps at the corner sends water across the slope or into a neighbor’s yard, so we run it to an existing drain, a buried line or out to the curb. We also use tighter hanger spacing on the taller rooflines where wind loads are higher.

Once a year on the flats, in late fall after the liquidambar and camphor drop. Twice a year if you are under oaks, pines or eucalyptus in the hills, because pine needles and eucalyptus bark keep coming through winter. If you would rather stay off the ladder for good, BroGuard micro-mesh handles most of it and the maintenance program handles the rest.