Gutter Installation, Cleaning & Repair in Pittsburg, CA

Probably. Sectional galvanized gutter from that era was good for twenty to thirty years, and the seams and end caps are usually where it gives up. If the seams drip, the hangers have pulled loose or the fascia is soft, replacement with seamless aluminum is the honest answer. If the runs are sound and only one section is failing, we will tell you that too.

It affects how we hang it more than what you buy. Wind off Suisun Bay works spike-and-ferrule hangers loose over time, so we use hidden hangers screwed into solid fascia at close spacing. Wind also blows dust and grit into gutters through the dry months, so outlets need to be clear before the first November storm.

Almost always too few downspouts. Builders often put one outlet at the end of a long run, so the trough fills faster than it drains and spills at the low corner. Adding a second downspout, or moving to a six inch gutter on the largest roof planes, usually solves it without replacing the whole system.

Once a year is enough for most homes here, ideally in late fall after the ash and mulberry trees drop and before the winter storms. Homes under mature street trees in the older neighborhoods may need a spring visit as well. If you would rather not think about it, the maintenance program handles the schedule and BroGuard cuts the need down further.

Yes, and it takes a different approach. Tile overhangs the fascia further than shingle, so the gutter has to be set to catch water coming off the tile edge without trapping it under the first course. We fit the gutter to the tile profile on site and protect the tile while we work, which matters on the newer subdivisions south of Highway 4.